BGC 2-axis/ 2-axle Brushless Gimbal Controller - Large Current Edition

Gimbal/ Gimbal Controller etc.

BGC 2-axis/ 2-axle Brushless Gimbal Controller - Large Current Edition | V3.0

BGC 2-axis/ 2-axle Brushless Gimbal Controller - Large Current Edition

- Hardware version: V3.0
- Adopts MOSFET replacing L6234D, provids higher driving power.
- Spare IIC port can connect to expansion board directly, no jump wire is needed.
- Can work at 5A continuously (heat sink is suggested in this case), and peak current up to 10A.

* THIS CONTROLLER CAN NOT BE FLASHED WITH OTHER VERSION FIRMWARES!

BGC 2-axis/ 2-axle Brushless Gimbal Controller - Large Current Edition | V3.0

Weight: 15g (including sensor and wire)
Main board size: 50 x 50mm
Continuous working current: 5A (when work at 5A continuously, heat sink is highly recommended)
Peak current: 10A
Power input: max 4S/ 16.8V (12V/ 3S is suggested)
Supported motor size: 2 to 8 series (motors for cameras from Gopro to Red Epic)

No customer review yet. [Write a review/question]

HAMID

Question :
Link of software ans Mother site?
March 04 2014 Was this question helpful to you?

Yes [ 0 ]

No [ 0 ] [Reply this question]

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.

Upload Image:
(Up To 5 Files, only .jpg/.gif/.png files are accepted and sizes below 2MB for each)

Post as: Review Question

Select grade: star(s)

Anonymous: Yes No

Please Log in with your account first.