40A BMC BRUSHLESS MOTOR CONTROLLER
SETUP MENU
BEC work under 3LIPO(10cell NIMh/NiCd)
5LIPO or 18 cells NIMh/NiCd MAX with BEC disabled
First, connect the motor and receiver to the speed controller
Remove battery power from the speed controller.
Turn on the transmitter.
Move throttle stick to full power position,(UP Position)
Reconnect battery power to the speed controller
After 3sec you can hear (all sounds are 3 times)
Main Menu:
∮— CELL Type AND Number
∮— — BRAKE
∮— — — TIMING MODE
∮— — — — PWM
When you need programming menu, move the throttle stick to middle position.
Submenu:
1. CELL Type AND Number
•— NiMh/Nicd AUTO（0.8V/CELL*）
•— — 3LIPO （2.75V/CELL）
•— — — 4LIPO（2.75V/CELL）
•— — — — 5LIPO（2.75V/CELL）
*IF used 2 LIPO you can use the option .(select the NiMh/Nicd AUTO)
2. BRAKE
••— NO
•••— — SOFT
•••— — — MID
•••— — — HARD
3. TIMING MODE
•••— 2 º
••••— — 7 º
•••••— — — 15º
•••••— — — — 30º
4. PWM
••••— 8KHZ
•••••— — 16KHZ
•••••••— — — 32KHZ
IF the option is you need ,then move the throttle stick to UP position.
The long BEEP is save the option. and the system will go to the programming menu.
You can setup other options.
When all you need options are setup OK, push the throttle stick to down position, after 1sec the system will save all options, then you can start the motor now.
HiModel Remarks:
∮ Signifys the rhythm the ESC emits
• Signifys short buzz
— Signifys long beep