JC60 EVO 60CC 2-Stroke Gas/Petrol Engine

- 2 Stroke air cooled single cylinder
- Walbro membrane pump carburetor with dual needles and manual choke
- Automatic advancing electronic ignition

Engine Parameter:

Engine type ： 2—Stroke gasoline engine
Displacement：60cc
　　 Bore × Stroke: 45mm × 38mm
　　 park plug: NGK CM6 or JC CM6
　　 Carburetor: Walbro special-designing vacuum pump diaphragm type duplex needle carburetor
　　 Max power ： 6.0hp/7500rpm
　　 Practical running speed ： 1100 － 7500rpm
　　 Net Weight ：1740g (incoulding CDI and muffler) Engine:1440g, pitts:180g, Ignition:120g,
　　 Ignition system ： CDI battery ignition (battery voltage: 4.8v—6v)
　　 Grease oil ratio ： 25-30:1 used during the break-in (the initial 2 working hours); 35-40:1 used after the break-in.
Screw propeller dimension ： 23*8, 23*10, 24*8, 24*10, 25*8

Muffler interface inner size: 26 x 14.8mm (approx.)
Muffler mounting hole spacing: 40mm (approx.)

Testing video:

Fly video:

Average Customer Review: 5 stars

4 customer review(s). [Write a review/question]

c****ato52
STD member

Grade:

Je suis à la recherche du plateau moteur du JC EVO 60. Si vous avait la pièce contactez moi et donnez moi votre prix.
Cordialement
September 14 2021 Was this review helpful to you?

Yes [ 0 ]

No [ 0 ] [Reply this review]

enio tosta
STD member

Question :

Hi . Need the cylinder - jc evo 60cc engine jacket
Do you have these? What is the price?
My email is eniotosta@outlook.com
August 21 2017 Was this question helpful to you?

Yes [ 0 ]

No [ 0 ] [Reply this question]

Barry Currie
STD member

Question :
I have a JC engine (44mm bore, 38mm stroke) but it does not have the words Evo on the head, only JC Engine. I thought it was a 50cc but I cannot remember and find one on any listings. It must be a 60. It had a knock in it from new and has had about 5 hours running, but it is sounding rough and the knock feels worse. I pulled it down to find the piston has scratches on it, with fine metal pieces in it also. The little end was sloppy, the big end was worse, the connecting rod seems to be the problem. The main bearings feel rough also. I used all the right oils and percentages running it in. Can I get parts or just throw it away. Will the 60 Evo parts fit? Eg the head along with the other parts.
June 09 2013 Was this question helpful to you?

Yes [ 0 ]

No [ 0 ] [Reply this question]

b****denbc31
STD member

Grade:

I love my JC Evo 60! Starts easy and has lots of power! I have never had a engine failure in flight. Will hover my 18 pound plane!
February 02 2013 Was this review helpful to you?

Yes [ 1 ]

No [ 0 ] [Reply this review]

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.

Upload Image:
(Up To 5 Files, only .jpg/.gif/.png files are accepted and sizes below 2MB for each)

Post as: Review Question

Select grade: star(s)

Anonymous: Yes No

Please Log in with your account first.