Specially designed for checking the unit cell voltage of Lithium polymer batteries, directly plug the voltage checker into the balance charging plug of the battery pack, it will display the voltage of each cell in turns from cell 1 to cell 3, and then repeat.
Once plug the voltage checker to the balance charging port of the battery, firstly it will show the voltage of first cell, there are 3 points on the LED screen which is used to indicate which cell it is measuring, when the point on right side light up, it indicates the first cell, and then will show the second cell voltage, and the middle point will light up, and then the third cell voltage, in the mean time, the left point will light up, if there is no second of third cell, it will display 'NO'.
Specifications:
[Dimension] 40 x 30 x 9 mm / 1.65x1.1x0.43 in
[Weight] 8 grams / 0.29 oz
[Operating Voltage] 0V to 4.3V (input voltage higher than 4.3V or wrong polarity may result in damage to the tester)
* The lowest pin is 'negative' when facing the LED.
*The battery checker is designed for checking the approximate voltage range of the Lipo cells, and not suit for accurate voltage measurement.
Comments:
The round point on the LED is not digital point, it is used for indicating the current cell, the right one denotes cell no. 1, the middle point denotes cell no. 2, the left point denotes cell 3.
So when you see the LED shows 38.7, it does not mean the voltage is 38.7V, but 3.87V for cell No. 2.
HiModel
Customer Reviews:
Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for
each)