- Optimised based on BLHeli firmware, good linearity and smooth starting. - Optimised for multicopter application, good filtering, also well support fixed-wing airplanes and helicopters. - Multiple protections: Low voltage protection, overheat protection and signal lost protection etc. - Lost found function: When the throttle keeps at low position, after some time, the motor will buzz to make it easier for you to locate the aircraft. - Throttle range re-calibration capable to best suit different receivers. - Some parameters can be set by either program card or transmitter.
Hint: When use CC3D flight control, requested by the flight control itself, you must use PPM or S.bus receiver to work in OneShot125 mode.
DALRC 2-4S 12A Speed Control for Multi-rotors BLHeli Firmware
Continuous current: 12A Burst current: 20A (for 5 seconds) Power input: 2-4S Lipo BEC output: No Supported firmware: BLHeli Dimension: 45 x 15 x 5mm Weight: 7.4g (including wires)
Includes: 1 x DALRC ESC 1 x instruction manual
Requires: 1 x receiver (RX)
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for