4-Pin 50CM Sensor Cable for BGC Series Gimbal Controller

Gimbal/ Gimbal Controller etc.

Wire type: super soft silicon wire
Weight: 2.5g
Wire length: 50cm (approx.)
Pin distance: 1mm
Connector pin numbers: 4-pin to 4-pin
Suitable controllers: BGC series or other controllers using same connectors.

Hint: Due to the design of I2C protocol, it doesn't suit for using long wires, when use this cable, it is suggested to increase the I2C signal level to increase the communication stability as shown in below diagram.

There are no customer review yet. [Write a review/question]

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.

Upload Image:
(Up To 5 Files, only .jpg/.gif/.png files are accepted and sizes below 2MB for each)

Post as: Review Question

Select grade: star(s)

Anonymous: Yes No

Please Log in with your account first.