FPV 5.8G 1000mW A/V Transmitting module, a good choice for long range video transmission.

FPV 5.8G 1000mW A/V Transmitter Module (TX)
video format supported: NTSC/PAL
Antenna connector: SMA  jack (module side)   Refer to here for connector type diagram
Power input: 7-15V (3S Lipo suggested, does NOT support 4S Lipo)
Transmitting current: 500mA (600mA at 12V under our real testing)
Dimension: 59x27x33 (excluding antenna) 
Weight: 52.9g (with antenna)

*Note: TX antenna must be installed properly before it is switched on, power on without install antenna, or a improper antenna was used may easily burn the TX, and such damage is not covered by warranty.

Includes:
1 x transmitting unit (TX)
1 x TX antenna (2db)
* No instruction manual supplied with this product.

Requires:
1 x receiving unit (RX)

The TX antenna is intentionally glued at factory, please do not try to remove it, TX damage due to replacing/removing the antenna is NOT covered by warranty.

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.