New 5.8G 1000mW Golden version.

- Upgraded ball bearing cooling fan, lower noise, and less vibration.
- Transmitting circuit is optimized, provides a longer range.

HiModel 5.8G 1000mW (1W) High Power Transmitting Module (TX) -Golden Edition

video format supported: NTSC/PAL
Connector type: SMA Jack (on the TX module side)    Refer to here for connector type diagram
Transmitting power: 1000mW
Power input: 7.4-13V (3S Lipo suggested, does NOT support 4S Lipo)
Transmitting current: 600mA @12V

*Note: TX antenna must be installed properly before it is switched on, power on without install antenna, or a improper antenna was used may easily burn the TX, and such damage is not covered by warranty.


* WRONG POLARITY WILL BURN THE MODULE, PLEASE DO VERIFY THE POWER SUPPLY POLARITY BEFORE YOU POWER IT ON.

Includes:
1 x transmitter (TX moudle)
1 x basic wire set

Requires:
1 x receiver

The TX antenna is intentionally glued at factory, please do not try to remove it, TX damage due to replacing/removing the antenna is NOT covered by warranty.

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.