Battery input support 2S-6S (7.4V-22.2V), USB output 5V (maximum output current 3A, according to the specific current device may be, if the iPhone standard charging current 800ma, output is 800ma, iPad standard charging current 2000ma, output is 2000ma . You can give any model phone, charging the same rate with the standard charger. By using the matching pin adapter cable can be used as an interface UBEC temporary use. Product comes with 1W LED lights for illumination.

Typical application:

Charging your mobile phone while discharging your Lipo battery
There is a flashlight module, you can also use it as a flashlight during discharge your Lipo battery. 

2S-6S LIPO to USB Charger / Lipo Discharger W/ Flashlight - XT60 connector

Input Voltage:  2S-6S LIPO (7.4V-22.2V) 
Output Voltage:  5V 
Input Interface:  XT60 connector 
Output Interface:  Standard USB port, pin interfaces 
Dimension:  50 x 25 x 15mm 
Weight:  18g

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.