Input voltage:4.5-35V Output voltage:1.25-30V adjustable Output current:constant 2A, Max 3A(with heat sink), heat sink must be attached when output is over 15W. (heat sink is not included in this unit) Efficiency:Max 92% Switching frequency:150KHz Minimum voltage difference:2V (the output voltage is lower than input voltage) Working temperature: -40℃ to +85℃ (output power within 10W ) Output ripple: Input 12V output 5V 3A 15mV(MAX) Input 24V Output 12V 3A 40mV(MAX) Wrong polarity protection: No, wrong polarity will burn the PCB directly. Dynamic respond speed:5% 200uS Short circuit protection:limit current, auto-resume Weight: 11.7g Size: 5x2.3x1.3 cm
*This device is specially introduced to those experienced DIYers, basic electronic knowledge and DIY/welding skills are required, we are not responsible for damages due to lack of welding skills or wrong wirings etc.
*Check the output voltage and adjust the virable resistor to adjust the voltage if needed before connect to your device.
Includes/Requires:
Includes: 1 x voltage regulator
* Wires are not provided, customers need to weld the input and output wires yourselves, so basic welding skills are required, also wrong polarity will cause severe damage to the unit.
Customer Reviews:
Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for
each)