The HiModel Fly Dream Servo Tester (version 2.1) allows the user to test and exercise servos and
set up a model without requiring the use of a transmitter and receiver.
The Servo Tester allows the user to control a servo directly, to determine its neutral position and to
cycle it automatically for break-in and testing.
The Servo Tester offers small size, low power, high reliability and easy operation.
It is easy to use, practical and can test most parameters that interest users.
Controlled by an SCM, it has good stability and high accuracy.
The Servo Tester is adaptable to different power sources: it can use a four-cell dry battery, NiCd or
NiMH pack; or it can be connected directly to a UBEC or ESC.
Average Customer Review: 3 customer review(s).[Write a review/question]
d****11
Grade: battery in BATT
servos in CH1 CH2 CH3 June 11 2013 Was this review helpful to you? Yes [ 0 ]
No [ 0 ] [Reply this review]
H****Electronic AB
Grade: you se which pins are connected together
the output signal from this unit is much better than from the more expensive GT power December 01 2011 Was this review helpful to you? Yes [ 0 ]
No [ 0 ] [Reply this review]
2****onepowerball
Grade: which pins are for battery and which are for servo(s)? no instructions supplied. October 24 2011 Was this review helpful to you? Yes [ 0 ]
No [ 1 ] [Reply this review]
Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for
each)