*Very light (10g / 0.4oz including wires & connector).

(The color of shrinking material may vary from the picturer.)

Type	Current	FET Qty	BEC	Timing	PWM	Li-poly	Ni-Mh
10-N	10A/13A	6	1.5A	Auto	8K	2 or 3 cells	4-12 cells

1.Extremely Low Resistance
2.High rate PWM
3.Sixteen cells MAX (with BEC disabled)
4.BEC (1.5A/4A) provides power to receiver and servos
5.2/3 Cell Li-poly switch:
2-pin jumper in:2-cell Li-Poly cutoff
2-pin jumper out: supports 3-cell Li-Poly cutoff
6.Safe power on arming program ensures motor will not accidentally turn on
7.Low torque soft start.


User guide

1.The main power cable can maximum of 20 cm length.
2.It is recommended to solder the cables directly to the power pack.
3.Plug the JR connector into the receiver throttle channel.
4.If using micro servos, it is necessary to reduce the number of servos by one.

Installing procedure:
1.Attach the motor to the motor mount with the screws provided.
2.Main power packs should be connected at one attempt. Avoid multiple touches of the connectors.
3.Power on the transmitter and check the throttle channel travel settings are +/-100% (for computer system radios.)
4.Power on the speed controller .
You must hear one 'beep'. Between switching on and hear the 'beep' the throttle stick must not be moved .If you do not hear a 'beep', power off the controller, and wait for 5 seconds then repeat the procedure again .
5.The position of 'full throttle' will be adjusted automatically.
6.Only have to exchange the position of any two wires connected to the motor then you can reversing the motor .

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.