Length of output shaft: 18mm (outside)
Diameter of output shaft: 5mm
Mounting holes spacing (opposite side): 31mm
Mounting holes spacing (same side): 11mm
Height from Bottom of Crankcase to Top of Cylinder Head: 80mm
Height from Bottom Mounting Ears to Top of Cylinder Head: 68mm
Width at Mounting Ears: 40mm
Length from Back of Pull Starter to End of Crankshaft: 96.5mm
*Please note that there are two versions .15 engines with same code 15CX-H (SKU SY15CX & SY15CX2 ), yet the specs are quite different, please read the specs carefully and make sure you choose the right one.
Includes/Requires:
Includes:
1 x engine with recoil starter
1 x muffler
Customer Reviews:
Average Customer Review: 6 customer review(s).[Write a review/question]
c****les borges
Grade:
Please, if it is possible, declare low invoice value in: 13,55 USD. Thank you.
September 11 2012 Was this review helpful to you? Yes [ 0 ]
No [ 0 ] [Reply this review]
e****
Grade: very good engine. December 05 2009 Was this review helpful to you? Yes [ 0 ]
No [ 0 ] [Reply this review]
p****to
Grade: Good engine. November 08 2009 Was this review helpful to you? Yes [ 0 ]
No [ 0 ] [Reply this review]
T****1976
Grade: Can i use it in a kyosho fw-05t? September 26 2009 Was this review helpful to you? Yes [ 0 ]
No [ 0 ] [Reply this review]
j****
Grade: Can iuse it in a HPI RS4 nitro?
thanks
Jinx July 09 2009 Was this review helpful to you? Yes [ 0 ]
No [ 0 ] [Reply this review]
d****a
Grade: good March 26 2009 Was this review helpful to you? Yes [ 0 ]
No [ 1 ] [Reply this review]
Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for
each)
Engines 
6 customer review(s). [Write a review/question]
Yes [ 0 ]
No [ 0 ] [Reply this review]
