OMNIBUS F7 Pro Flight Controller W/ OSD BEC | (Betaflight 3.2.0 firmware)

- STM32 F745 MCU - faster than the current F3 and F4 processors
- Two gyros on the flight controller: an MPU6000 for sampling up to 8khz and ICM20608 for sampling up to 32khz
- Built in betaflight OSD
- Built in Current sensor
- Built in 5V LC-power filter
- Built in Barometer 
- D-shot esc Support（Dshot600 Ready）
- 36x36mm, mount holes 30.5x30.5mm
- Weight: 6.6g
- SD card reader for recording black box data (SD card not included)
- Supports 2-4s natively, 5-6s with 220uf 35V capacitor
- 5v/1A regulator
- Support PPM/SBUS/IBUS/DSM2/DSMX protocol receiver
- LED_strip ready pin headers 
- Buzzer ready pin headers
- Smart port ready Pin headers
- Compatible 4 in 1 ESC with JST-SH 1.0 6pin housing
- Firmware version: Betaflight 3.2.0 OmnibusF7

Includes:
1 x  OMNI F7 Pro Flight Controller 
4 x  Nylon poles
4 x screws
4 x nuts
3 x  set pins

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.