This is a power distribution hub specially designed for multi-rotor speed controller connection.
Well matched with KK flight control unit, also can be used for other multi-rotor application.
It makes the wiring of your multi-rotor system neater, nicer, securer.
Installation method:
1. Weld the power input wires of ESCs to the hub, suggested inner circle for "+", and outter circle for "-".
2. Isolate the hub with tape or shrinking tube, or use double side tape to fix it to the main frame of your multi-rotor aircraft.
Specifications:
Max ESC number: 8
Size: 5 x 5cm
Weight: 8g
Fixing hole diameter: 3.5mm
Includes/Requires:
Includes:
1 x wiring hub
* This is a PCB board for easier wiring purpose, and does not include ESC or other accessories.
Customer Reviews:
Average Customer Review: 3 customer review(s).[Write a review/question]
A****eo Lee
Question : May I know how do you check that it is 45A each esc? By the way, what is the total amps for this board? September 28 2013 Was this question helpful to you? Yes [ 0 ]
No [ 0 ] [Reply this question]
Mikrodrohne
Grade: Hi,
I have checked the maximum currend, it is 45A each esc!
Working well on my 1,2mtr octocopter July 22 2013 Was this review helpful to you? Yes [ 1 ]
No [ 0 ] [Reply this review]
a****salplain
Question : What is max power load in Amps (total and for each ESC?
June 25 2012 Was this question helpful to you? Yes [ 2 ]
No [ 1 ] [Reply this question]
Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for
each)