GF 11x4.7 High Rigidity Nylon Mix Carbon Propeller Set (one CW, one CCW)

This is the new GF Nylon mix carbon propellers specially designed for multi-rotor aircraft application.

- Nylon mix carbon material, the rigidity is 3 times of common Nylon props.
- Higher efficiency.
- Less deformation under high load.
- Lower noise.

GF High Rigidity Nylon Mix Carbon Propeller Set
Size: 11x4.7 inch
Hub thickness: 6.8mm
Weight: 14g/ 0.5oz (each)

* The photo is for reference only.

Includes:
1 x clockwise rotating propeller
1 x counter-clockwise rotating propeller
1 x adaptor ring set

Average Customer Review: 5 stars

1 customer review(s). [Write a review/question]

vtolman

Grade:

These are almost as good as carbon props but much cheaper.
Far more rigid than standard plastic and they won't break in flight.
They are quiet and efficient and light.
I use them on tricopters and vtol planes with the LD power 2216 800 and they perform as per the specs shown for 11 x 4.7
They all need a little balancing as expected.
I balance them on a needle through the hub center and add tape to middle of the lighter blade side - very easy.
Good customer service from my experience with Himodel so far.
April 20 2015 Was this review helpful to you?

Yes [ 0 ]

No [ 0 ] [Reply this review]

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.

Upload Image:
(Up To 5 Files, only .jpg/.gif/.png files are accepted and sizes below 2MB for each)

Post as: Review Question

Select grade: star(s)

Anonymous: Yes No

Please Log in with your account first.