22g/ 4.6kg/ .14 sec Digital Ball Bearing Servo DS-238MG

- Ball bearing
- Digital with MOSFET Drive
- Metal gear

Type: DS238MG
Size: 29x13x30mm(1.14"x0.51"x1.18")
Weight: 22g(0.77OZ)
Operating voltage: 4.8V / 6.0V
Operating current: 300mA / 400mA
Operateing speed: 0.15sec.60º/ 0.14sec.60º
Stall torque: 4kg.cm / 4.6kg.cm
Dead band: ≤3uSec
Operating speed: 40º/one side pulse traveling 400us
Potentiometer: 3 slider/Indirect Drive
Ball bearing: MR106
Gear Material: Metal
Connector wire length: 215mm
Temperature: -20 ℃ to +60℃

Includes:
1 x digital servo with servo horns

Average Customer Review: 5 stars

3 customer review(s). [Write a review/question]

vtolman

Grade:

Strong servos and good centering.
I use about 7 on different vtol planes to tilt two front motors and on tricopter motor tilts etc.
Gears must be good I've had some bad crashes and only broke the servo arms and never stripped the gears so far.
The standard Futaba 25 tooth spline arms fit.
April 19 2015 Was this review helpful to you?

Yes [ 0 ]

No [ 0 ] [Reply this review]

JR24067

Grade:

These are incredible servos. They come with a nice accessory package of heavy duty nylon control arms (3) and nice mounting hardware. I used two of them in my Super Sportster Electric for elevator and rudder and they are plenty strong and quick.
click to view

September 16 2013 Was this review helpful to you?

Yes [ 0 ]

No [ 0 ] [Reply this review]

d****s.carre01
Golden member

Grade:

These servos are incredible : they are very cheap, but they've got very high accuracy and torque

I use them on my F3A and my GFK gliders and it works perfectly !

Great value for the price
September 04 2012 Was this review helpful to you?

Yes [ 4 ]

No [ 0 ] [Reply this review]

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.

Upload Image:
(Up To 5 Files, only .jpg/.gif/.png files are accepted and sizes below 2MB for each)

Post as: Review Question

Select grade: star(s)

Anonymous: Yes No

Please Log in with your account first.