7 channel synthesizing PPM receiver. Never use crystals again! Dial up any frequency in the 36Mhz range instantly
You can set the frequency in the receiver by following these instructions:
Plug a battery into the RS70 receiver and turn power on.
Turn on the transmitter and place it 1 metre from the receiver.
Press and hold down the “SCAN” button on the end of the receiver for more than 2 seconds.
Release the “SCAN” button for 2-3 seconds, then press the “SCAN” button again for ½-1 second.
The LED will flash on and off quickly during the scanning process and once this process is completed the LED will stay solidly lit.
If the LED flashes slowly then there has been a problem with the scanning procedure and you should repeat the procedure after checking that the receiver battery has sufficient voltage and that there are not any other transmitters in the close vicinity of your receiver.

Type: RS70
Band: 36Mhz
●FM/PPM 7ch receiver
●Available for FM transmitter (PPM mode)
●Auto Scan System
●Measurement:15x25x47mm
●Weight: 17g

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.