1, surface treatment In places where covering film is required, the surface must be carefully polished. It is best to use a fine sandpaper of 320° to polish and clean the wood powder on the surfaces. Pay special attention to the surface that can't have paint or oil on the board surface, otherwise it will not stick to the board.
2, the temperature of the iron Apply a layer of cotton cloth to the soleplate of the iron before using the iron. The low temperature of 100 ° C - 120 ° C can make the film produce a sticky force and adhere to the board. The medium temperature of 150 ° C is the optimum bonding temperature. 180 ° C high temperature, can shrink the film and tighten it up.
63.8 x 200 cm Covering Film FM08-101B - Bright Red
Width: 63.8cm Length: 2 meters
Includes: 1 x covering film
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.
Upload Image: (Up To 5 Files, only .jpg/.gif/.png
files are accepted and sizes below 2MB for