The 7C sits squarely in the middle ground in computer systems. It's a system that offers much of the 9C's set-up versatility matched to 4-channel ease of use. Like all other computer systems on this page, it offers Dial n' Key simplicity for programming, and the 2.4GHz FASST system for an unparalleled RF link.

7C System Specifics:

* Dial 'n Key programming

* Airplane/heli software

* Assignable switches/functions

* Up/down timer

* Mode 1-4 selectable (modes 3 and 4 available via transmitter software)

* Large 72 x 32 LCD screen with adjustable contrast

* 10-model memory

* 6-character model naming

* Digital trims, trim memory, EPA, subtrims and servo reversing (all channels)

* Dual/Triple rates* (aileron/elevator/rudder)

* Exponential (aileron/elevator/rudder)

* Adjustable throttle cut

* Fail-safe

* NT8S600B 600mAh Tx NiCd w/dual-output charger FBC-2J

* Trainer system (cord required)

* Flap switch

* Retract switch

* Variable rate knob (channel 6)

Airplane Advanced Menu:

* Ailevator feature simplifies dual servo set-ups on elevators

* 3 programmable mixes

* Flaperon

* Flap trim

* Air brake

* Elevator to flap mixing

* V-tail mixing

* Elevon mixing

* Aileron to rudder mixing

* Snap roll

R617FS FASST Receiver
Size: 1.6 x 1.1 x .35" (40 x 27 x 9mm)
Power Requirement: 4.8 - 6V
Current Drain: 80mA (at no signal)
Weight: 0.34oz (9.8g) with case, 0.25oz (7g) without case

Includes:
1 x Futaba 7C 2.4GHz Transmitter
1 x R617FS FASST 7-Ch Receiver (FUTL7627)
1 x charger FBC-2J 230V Battery Charger two round pins
1 x NT8S600B 600mAh 9.6V NiCd Transmitter Battery (FUTM1457)
1 x Switch Harness w/Charge Cord (FUTM4370)
1 x Instruction manual (English)

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.