DN POWER G3 (6S4A) Li-Ion / Li-Polymer charger is a high-performance parallel charger. It will monitor voltage and charging current of each cell in real time, with 24-digit A/D converter accuracy. In addition, it can measure and record data during a controlled discharge and communicate charging and discharging data to your computer.

Its powerful software can download charging and discharging history and curves, as well as adjust some of the G3's settings. This allows you analyze battery capacity and monitor changes in your batteries performance.
1. Charging Features :

* Charges 1-6 cell Li-Ion / Li-Polymer battery in parallel (monitors and controls voltage and current to each cell)
* Charging current is adjustable from 0.5A to 4A in .5 A steps
* Real time display of each cells charging current (A) or charged capacity (mAh) on the LCD screen.
* Charger will automatically stop charging and signal (beep) when all cells are completely charged.
* Can save the last 256 charging records, including charged capacity and end of charge status of each cell.
* Saves the charging curve of each cell during last charging.
* Safety protection for reversed polarity.

2. Discharge Features:

* Discharge up to 10-cell (37 V) Li-poly battery.
* Adjustable Cut-off voltage and discharging current. (Maximum discharge power is 50W)
* LCD display Shows discharging time and voltage and discharged capacity.
* Discharging curve can be viewed on computer.

3. PC Communications:

* High speed USB connection.
* Display last charging record including charging curve.
* Adjust charger settings.
* Control online discharging, analyze battery’s capacity and display discharging curve.

Download driver & software here: G3 Manager Setup Software , 6P4A Charger management Software

Includes:
1 x DN Power charger
1 x DC power source cable
1 x USB high quality cable
1 x 6S to 2S+4S convert cable
1 x 6S to 2S+2S+2S convert cable
1 x 6S to 5S convert cable
1 x 6S to 3S+3S convert cable
1 x English manual

(* The G3 extension , also know as cascade charging dock is not included, to be purchased separately)
*The new G2 Plus and G3 charging port are compatible with HiModel series battery charging connectors, no polarity reverse cable are necessary as old G2 or spirit chargers.

Note:
Requirement of power supply: +12VDC, power should be over 150W with overload protection. Notice should be taken for the estimated voltage and the capacity in case of a lead battery. For multi-pack charging function, it is therefore greatly advised that lead battery should not be used as the main power supply.

Trouble shooting:
When use the G3 extension , the charging mode must be set to PA0.

There is a delay about 4-5 seconds once you press Start/Stop till the EX-6 to respond, so please be patient once you press Start.

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.