1. Power Input:10-15V DC
2. Output Current:8.4V (4.2V x 2), or 12.6V ( 4.2V x 3) x 1, or 16.8V (4.2V x 4) x 1.
3. 1.0A charging current and 4.2V charging voltage charging technique.
4. Auto adjustment of the charging current at voltage peak region. Auto-cut off when battery cell is full charged.
5. The innovative charger for 1-4 cells of Li-ion or Li-po battery packs, It can be used to charge 4 ea 1 cell pack ( optional by using 2 ea switch chaging cable for ports of 7.4V), or 2 ea 2 cells pack, or 1 ea 3 cells pack or 1 ea 4 cells pack.
Note: the charger can not charge over 4 cells at the same time. For example, 11.1V ( 3 cells ) battery and 7.4V ( 2 cells) battery, or 11.1V (3 cells) battery and 11.1V (3 cells) battery charged at the same time are not allowed.
6.LED indication, red color for charging, green color for charger ready or battery cell full charged.
7.Instead of charging all cells of the battery pack serially, this charger will independently control charging process of each cell of the battery pack, it will completely eliminate the interference between cells of the battery apck during charging process. It will also avoid the possibility of burnt or explosion caused by a problem battery pack with defective cell inside.
8. Sturdy aluminum case & exhaust fan for maximum heat dissipation.
9.Auto-cut off charger operation when voltage of the power source is lower than 9V. All LED will be light off.
10. Size: 130x80x30mm.
11. Weight: 290g.

Requires:
10-15V DC power source

Connector compatible with all HiModel Lithium Polymer battery packs.

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.