Designed for Model Helicopter Use.
Longer Throttle Arm for Clearance of Frame Sides.
Push-Pull Throttle Linkage Arm.
Large Heat Sink Head for Greater Cooling

Displacement: 9.95cc (0.607 cu.in.)
Bore: 24.0mm (0.945 in.)
Stroke: 22.0mm (0.866 in.)
Practical rpm: 2000-18000 rpm
Power Output: 2.0bhp/ 16000 rpm
Crankshaft Thread Size: 5/16 x 24
Weight: 541g (19.1 oz.)
Length: 115mm (4-9/16 in.)
Width: 42.6mm (1-5/8 in.)
Height: 96mm (3-5/8 in.)
Needle Valve Setting: 1-1/2 Turns Out From Fully Closed
Exhaust Bolt Spacing width - 42mm(1.65")

Includes:
One .61LX-H Helicopter Engine
One #60G Carburetor
One Woodruff Key
One Glow Plug
One Instruction Sheet, Decal, and Warranty Information

REQUIRES:
Glow Plug: #A5 or #8
Helicopter Fuel: 12.5%, 15% or 30% Nitromethane and 18% Lubrication
After Run Oil
Muffler or Tuned Pipe and Header (Depending On Helicopter)
Starting Equipment (Located In Helicopter ACG)

Please explain:
Messages of this section are not monitored by HiModel, it is for review and discussion among customers only.